Spin Semiconductor

Hello, i wrote a simple routine to perform decimation on samples, and i placed a 1 pole LPFs ahead to prevent aliasing but i'm not able to completly get rid of high freqencies ringing cause the slope of 1st order could be too low. I could probably resolve this by analog conditioning at the input sid...

Ok i did some test with in/out gain and the noise drops to acceptable levels. With my strat if i hit hard on the low E i can get 2-3V peak which is two times the max input of the FV-1... Need for smart gain here My goal, before i even start to write a single instruction on this device, is to retain ...

The signal path is very easy: guitar-->buffer-->fv-1 board-->buffer-->amp I am driving the ADC input with guitar level which is too cold but i expected little less output noise. This morning i will adjust the in/out gain to match the ADC full scale. If the noise comes from the A/DAC i should get som...

I have put the scope at the FV-1 output and it shows 10mVpp noise with or without grounded inputs. Looking at the FFT it shows that the noise level is full band. I tried to power it with 9V Battery, same thing. I have to assume that the noise comes straight from the FV-1. How can you use such a thin...

Hi everyone! I just got my fv-1 eval board but i find there is too much "hiss" type of noise. It's not PSU related cause i supply it with dedicated PSU; it's not a 100Hz hum, it sounds like a "shhhhhhh". :) I tryed putting a buffer pedal on the input, on the output, tryed to grou...