Search found 4 matches
- Wed May 27, 2015 12:37 pm
- Forum: FV-1 hardware questions
- Topic: FV-1 reverb pedal build help/advice
- Replies: 6
- Views: 7760
Thanks Frank, I appreciate the help and direction. I have emailed the designer of the board and am waiting for a response. In the meantime I'll check for a short. I noticed that the solder on two pads of the pot connections were a little close but there seems to be space between them. I'll be even m...
- Tue May 26, 2015 6:54 am
- Forum: FV-1 hardware questions
- Topic: FV-1 reverb pedal build help/advice
- Replies: 6
- Views: 7760
There was a 3.3v regulator included with the board and only one way to solder it to the pads. I checked for voltages last night and they seemed fine. I tried again this morning and they seemed to be jumping around a bit. The fv-1 was warming up after a few seconds so i unplugged it. He did mention I...
- Mon May 25, 2015 8:03 pm
- Forum: FV-1 hardware questions
- Topic: FV-1 reverb pedal build help/advice
- Replies: 6
- Views: 7760
- Mon May 25, 2015 4:57 pm
- Forum: FV-1 hardware questions
- Topic: FV-1 reverb pedal build help/advice
- Replies: 6
- Views: 7760
FV-1 reverb pedal build help/advice
Newer than new noob (more of a solder by numbers guy) so here go's. I built up an FV-1(chip from small bear) reverb board by aresaudio and fired it up and I have sound in bypass, when the "wet/dry" pot is fully ccw to dry. But when I turn it clock wise to add in the reverb the dry signal d...