Search found 3 matches
- Sun Nov 30, 2008 9:36 pm
- Forum: FV-1 hardware questions
- Topic: What to connect to the MID pin?
- Replies: 1
- Views: 4924
What to connect to the MID pin?
Forgive me if I've overlooked something in the spec sheet, but what exactly should I do with the MID pin in a new design? The Typical Application circuit in the spec sheet shows it connected to a 1uF cap whose other leg is connected to ground. The schematic for the development board shows a 10uF pol...
- Thu Nov 13, 2008 8:51 am
- Forum: FV-1 hardware questions
- Topic: Protecting the input pins
- Replies: 2
- Views: 5641
- Mon Nov 10, 2008 10:10 am
- Forum: FV-1 hardware questions
- Topic: Protecting the input pins
- Replies: 2
- Views: 5641
Protecting the input pins
The data sheet for the FV-1 says "Although the FV-1 is fully digital internally, it has been designed with internal power supply bypassing and careful attention to signal pin protection devices so that only a clean power supply and expected analog techniques are required at the PCB level."...