Page 1 of 1
DIY Eurorack for FV1
Posted: Mon Jan 01, 2018 10:19 am
by murrayadam
I want to eurorack my FV1 (When I get it) has anyone done this or something similar? I assume it would be as simple as mounting the board on a faceplate and connecting up some pots and the audio connections. Will it be possible to de-solder the audio connections and pots to mount new ones on a faceplate?
Posted: Mon Jan 01, 2018 12:10 pm
by frank
The FV-1 is the chip not a board, do you mean a dev board? If so you might want to see if you need any buffering, I do not know if there is any standard for euro rack signal levels. Also you risk damaging the board by pulling/replacing connectors.
Posted: Tue Jan 02, 2018 1:03 pm
by murrayadam
Yes I mean the board. Perhaps it would be more logical to build a module to send and return signals to the unit and perhaps place it on the top of my system. This would make it easier to power from a PSU rather than my Eurorack case as I would need to step down from 12v.
Posted: Wed Jan 10, 2018 8:35 pm
by Digital Larry
Posted: Thu Feb 08, 2018 8:32 am
by MacroMachines