I see that the GA_DEMO and Mixer demo boards have program pins installed on SDA and SCK of the FV-1. What are you guys using to program in circuit? I've just been using the socket on the dev board and then popping the EEPROM on the finished board, but I'd like to go to SMD EEPROMS.
Thanks,
Matt Farrow
I2C EEPROM Programming - in circuit
Moderator: frank
-
- Posts: 34
- Joined: Thu Nov 09, 2006 6:58 am
- Contact:
You basically have 2 easy options:
Use one of those 8-pin headers that you can put parts on (similar to http://www.precicontact.ch/uw%20sw%20w%20scket.htm) and solder wires and a 3-pin adapter to it to so it plugs in to the socket in place of the EEPROM and use the development board as the programmer.
Any programmer that can program the EEPROM and make a similar adapter.
Use one of those 8-pin headers that you can put parts on (similar to http://www.precicontact.ch/uw%20sw%20w%20scket.htm) and solder wires and a 3-pin adapter to it to so it plugs in to the socket in place of the EEPROM and use the development board as the programmer.
Any programmer that can program the EEPROM and make a similar adapter.
Frank Thomson
Experimental Noize
Experimental Noize
-
- Posts: 34
- Joined: Thu Nov 09, 2006 6:58 am
- Contact: