Hi Guys.
At the beginning I want to say sorry for my english, I'm Polish
---
I have a problem with bit crusher effect. I've looked everywere, but I can't find a finished version of it. So I want to please You, could anyone send me code of this effect for FV-1 ?
Thanks a lot.
Bit Crusher Effect
Moderator: frank
Hi.
Thanks for this. I have programmed my FV-1 with 8 diffrent versions of this effect (diffrent ratio) and this effect is really good for me.
But there is one thing I want to do - how could I make, for example, POT1 to set ratio ? I want to do regulation of this effect (most linearly as possible). Could You do this for me ?
Thanks again.
Thanks for this. I have programmed my FV-1 with 8 diffrent versions of this effect (diffrent ratio) and this effect is really good for me.
But there is one thing I want to do - how could I make, for example, POT1 to set ratio ? I want to do regulation of this effect (most linearly as possible). Could You do this for me ?
Thanks again.
I do not have the time to write the code but if you try and have problems then post it and I'll look at it. You'll want to use the POT input to do skips in the code to select different mask values. See http://www.spinsemi.com/forum/viewtopic.php?t=343 where skipping based on pot value was done.
Frank Thomson
Experimental Noize
Experimental Noize