Hey Guys,
Am not able to get my head around programming the SKRM modules...
I have a pickitII programmer and have followed the guide that was laid out in the etapper pdf.
I have picKITII connected like this
PICKITII SKRM(eeprom)
PGC SCLK
PGD SDAT
and ground
I have the module powered and set to program 1 but am unable to read or write anything.
I'm unsure as to teh whole process, I have exported a project from SpinASM which has my 8 programs exported into a hex file, this is what Im loading into PICKITII software and trying to write, but as I said, I'm not even able to read the contents of the fv-1 eeprom at the moment.
Any help/advice would be much appreciated. I've been messing around with it all night
thanks
info on programming teh SKRM module with a pickit.
Moderator: frank
-
- Posts: 2
- Joined: Tue Mar 11, 2014 5:53 am
Focus on reading for now, check the voltages and that you have the wiring correct. If you have a scope look at the clock and data lines when you try to read.
Frank Thomson
Experimental Noize
Experimental Noize
Re: info on programming teh SKRM module with a pickit.
It looks like you're using the wrong pins on the Pickit. It should be PGC (pin 5 on the pickit) to SCLK and Aux (pin 6 on the Pickit) to SDAT.bradholland wrote:Hey Guys,
PICKITII SKRM(eeprom)
PGC SCLK
PGD SDAT