I need your help please:
here is a part of a very simple, basic delay program, just to understand how this goes.
delay time control pot is quantized in 16 parts as explained in knowledge base.
Hardware is the evaluation board, not my design.
Code: Select all
rdax pot1, 1
and %01111000_00000000_00000000
wrax addr_ptr, 0
rmpa 1
wrax dout, 1
On top of that, the offset goes worst with faster delay settings:
1st step 64BPM 1 bar
9th step 62BPM 1/2 bar
13th step 60BPM 1/4 bar
15th step 58BPM 1/8 bar
how can this be fixed?
thank you very much!