I know that the Spin IDE can generate HEX from a project, but I'm wondering if there is a way, using Spin IDE or some other tool maybe, to program the dev board using a HEX file?
I understand that I could use a PICKit 2 connected directly to the E-squared i2c lines, but I just want to use the dev board USB directly.
Thanks,
DL
Using HEX to program dev board using Spin IDE
Moderator: frank
-
- Posts: 338
- Joined: Mon Nov 12, 2012 1:12 pm
- Contact:
To the best of my knowledge, no there isn't. As far as I know, but I did not write the code so from what I was told, SpinAsm does not have a hex read routine only a write routine so is can't parse a hex file.
Frank Thomson
Experimental Noize
Experimental Noize
-
- Posts: 338
- Joined: Mon Nov 12, 2012 1:12 pm
- Contact: