Clip output to CPU interface

Hardware questions and issues with the FV-1

Moderator: frank

Post Reply
dslocum
Posts: 13
Joined: Mon May 21, 2012 9:34 am
Contact:

Clip output to CPU interface

Post by dslocum »

I'm interfacing a CPU with a LCD to the FV1. I would like to use the CLIP output pin into a CPU input - maybe an interrupt on change input so that the LCD displays the clip event rather than a hardware LED.

Is the CLIP output a standard open drain output? Should I pull up with something like a 10K? Any other gotchas?

Thanks
frank
Posts: 1244
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank »

I believe it is a standard output pad that goes low when the signal clips, I do not believe you need a pull-up.
Frank Thomson
Experimental Noize
Post Reply