where to connect unused input/output ?

Hardware questions and issues with the FV-1

Moderator: frank

Post Reply
gkaiomenos
Posts: 9
Joined: Thu Oct 16, 2014 11:59 am

where to connect unused input/output ?

Post by gkaiomenos » Wed Apr 05, 2017 3:57 pm

I am using the chip on mono mode and wondering where it would be best to connect the unused I/O pins to minimize noise.
Should that be straight to reference (pin3) or maybe via a resistor or capacitor?
Any thoughts are welcome

frank
Posts: 991
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank » Wed Apr 05, 2017 9:53 pm

Best to drive both inputs with the signal and leave the unused output unconnected to anything.
Frank Thomson
Experimental Noize

gkaiomenos
Posts: 9
Joined: Thu Oct 16, 2014 11:59 am

Post by gkaiomenos » Fri Apr 07, 2017 4:38 am

frank wrote:Best to drive both inputs with the signal and leave the unused output unconnected to anything.
So should I just jumper both inputs or maybe use separate signal cap to each input ??

frank
Posts: 991
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank » Fri Apr 07, 2017 8:47 am

Separate signal caps.
Frank Thomson
Experimental Noize

gkaiomenos
Posts: 9
Joined: Thu Oct 16, 2014 11:59 am

Post by gkaiomenos » Sun Apr 09, 2017 2:42 pm

frank wrote:Separate signal caps.
Great. I'll try that.
Thank you!

Post Reply