Accutron
Posted: Wed Jun 02, 2010 2:44 pm
Hi,
I'm new to the group and I'm finding the navigation a bit unusual. Please excuse me if I don't post correctly.
I was wondering if anyone has developed an interface to allow the development board to replace an Accutronics spring reverb in a vintage musical instrument amplifier. (Make sure it has a 3 wire ground!).
I had just purchased a development board and wondered how I would mix wet and dry signals. I have Fender amps available, and that may be the best solution.
Thanks in advance for any hints.
Best Regards,
Jim S.
I'm new to the group and I'm finding the navigation a bit unusual. Please excuse me if I don't post correctly.
I was wondering if anyone has developed an interface to allow the development board to replace an Accutronics spring reverb in a vintage musical instrument amplifier. (Make sure it has a 3 wire ground!).
I had just purchased a development board and wondered how I would mix wet and dry signals. I have Fender amps available, and that may be the best solution.
Thanks in advance for any hints.
Best Regards,
Jim S.