I just want to hear the bass frequencies.
I do not want mid and treble.
because I have to use your microphone
s letter-letter z - such as the high-frequency very bad.
please help me. thank you very much.
delayd mem 4096 ; Down delay
temp mem 1 ; Temp location for partial calculations
;
skp run,START
;
wldr RMP0,16384,4096
wldr RMP1,-8192,4096
;
START: ldax ADCL
; Write it to left delay and clear ACC
wra delayd,0
; Read in left
ldax ADCL
;
wra delayd,0
;
cho rda,RMP0,REG|COMPC,delayd
cho rda,RMP0,,delayd+1
wra temp,0
cho rda,RMP0,RPTR2|COMPC,delayd
cho rda,RMP0,RPTR2,delayd+1
cho sof,RMP0,NA|COMPC,0
cho rda,RMP0,NA,temp
mulx POT1
wrax REG0,0
;
cho rda,RMP1,REG|COMPC,delayd
cho rda,RMP1,,delayd+1
wra temp,0
cho rda,RMP1,RPTR2|COMPC,delayd
cho rda,RMP1,RPTR2,delayd+1
cho sof,RMP1,NA|COMPC,0
cho rda,RMP1,NA,temp
MULX POT2
wrax REG1,0
;
ldax ADCL
mulx POT0
rdax REG0,1.0
rdax REG1,1.0
wrax DACL,1.0
wrax DACR,0
my octave problem
Moderator: frank
I'm not sure what you are asking exactly but if you just want bass range frequencies then you just need to add a low pass filter to the input of the code.
Frank Thomson
Experimental Noize
Experimental Noize
-
- Posts: 10
- Joined: Mon Jun 27, 2011 4:11 pm
octave
frank
but I do not know
how do
please write
my code Edit
please
thank you very much
but I do not know
how do
please write
my code Edit
please
thank you very much
Have a look here http://www.spinsemi.com/knowledge_base/ ... .html#WRLX
and here, which shows the formula for calculating the coefficient to set the corner frequency.
http://www.spinsemi.com/knowledge_base/ ... ng_filters
and here, which shows the formula for calculating the coefficient to set the corner frequency.
http://www.spinsemi.com/knowledge_base/ ... ng_filters
-
- Posts: 10
- Joined: Mon Jun 27, 2011 4:11 pm
octave
input where?
I do not know
my english very bad
I can not
We produce audio & guitar amp mixer
We do not know our problem is to write code
thank you very much
I do not know
my english very bad
I can not
We produce audio & guitar amp mixer
We do not know our problem is to write code
thank you very much
OK, if you are a manufacturer then you should be able to get help from the distributor you are getting the parts from. They should be able to help you modify the code to fit your needs.
Frank Thomson
Experimental Noize
Experimental Noize
-
- Posts: 10
- Joined: Mon Jun 27, 2011 4:11 pm