SKRM-C8 2-pin prog. header & quartz positioning...
Posted: Tue Feb 19, 2013 8:28 pm
Hi Frank !
I plan cramming 3 SKRM-C8 boards in a small 1590B Hammond box; since space is real tight, I'm wondering if it's O.K. to unsolder the 2-pin programming header (& probably quartz U102 as well) and reposition/resolder them on the 16-pin header side... any technical reasons I should not attempt this ? (well, other than a "SpinSemi does not recommand..."-type disclaimer, I guess)
TIA !
(ideally, it's the 16-pin header that should be moved to the component side for optimal "compactness", but I'm not going there unless you tell me it's actually safer...)
I plan cramming 3 SKRM-C8 boards in a small 1590B Hammond box; since space is real tight, I'm wondering if it's O.K. to unsolder the 2-pin programming header (& probably quartz U102 as well) and reposition/resolder them on the 16-pin header side... any technical reasons I should not attempt this ? (well, other than a "SpinSemi does not recommand..."-type disclaimer, I guess)
TIA !
(ideally, it's the 16-pin header that should be moved to the component side for optimal "compactness", but I'm not going there unless you tell me it's actually safer...)