Page 1 of 1
Bit Crusher Effect
Posted: Fri Mar 15, 2013 3:14 pm
by ZibiSound
Hi Guys.
At the beginning I want to say sorry for my english, I'm Polish
---
I have a problem with bit crusher effect. I've looked everywere, but I can't find a finished version of it. So I want to please You, could anyone send me code of this effect for FV-1 ?
Thanks a lot.
Posted: Sun Mar 17, 2013 2:24 pm
by frank
Posted: Wed Mar 20, 2013 11:34 am
by ZibiSound
Hi.
Thanks for this. I have programmed my FV-1 with 8 diffrent versions of this effect (diffrent ratio) and this effect is really good for me.
But there is one thing I want to do - how could I make, for example, POT1 to set ratio ? I want to do regulation of this effect (most linearly as possible). Could You do this for me ?
Thanks again.
Posted: Thu Mar 21, 2013 9:14 am
by frank
I do not have the time to write the code but if you try and have problems then post it and I'll look at it. You'll want to use the POT input to do skips in the code to select different mask values. See
http://www.spinsemi.com/forum/viewtopic.php?t=343 where skipping based on pot value was done.
Posted: Thu Mar 21, 2013 11:27 am
by ZibiSound
There is little problem - I don't know how to do this... I can't write effects
Could You do this for me when You'll have some time ? Please.
Posted: Fri Mar 22, 2013 5:07 am
by Sweetalk
sebxx4 wrote:There is little problem - I don't know how to do this... I can't write effects
Could You do this for me when You'll have some time ? Please.
So start reading the knowledge base and try to learn first!
Posted: Fri Mar 22, 2013 11:45 am
by ZibiSound
You were doing this effect. Have You done it ? May could You upload your version of this effect ?