There is a very good freeze infinite reverb in free DSP program section (the reverb+pitch-LP program written by DAVE SPINKLER).
A simple 2 position momentary switch (center pin POT0 , the others two pins goes to ground and 3,3v) can be used to obtain the freeze effect.
A simple question : when I release the switch, pot0 turns to ground and the freeze effect disappear instantly. Is it possible to fade away the freeze effect instead ?
infinite FREEZE reverb
Moderator: frank
That code was designed to use a pot, not a switch. If you want it to fade away you will need to change the code around the routine that reads the pot to return a non-zero value when the input is low.
Frank Thomson
Experimental Noize
Experimental Noize
OK,
I've made this using the infinite reverb program :
https://www.youtube.com/watch?v=uDttB9gZ-xs
Now the question : I want to select semitones (12 semitones) with pitch pots. This is possible with pot skip routine but.... how can I write it ?
I've made this using the infinite reverb program :
https://www.youtube.com/watch?v=uDttB9gZ-xs
Now the question : I want to select semitones (12 semitones) with pitch pots. This is possible with pot skip routine but.... how can I write it ?
Basically read the POT, subtract 1/12, if negative then skip to first routine else subtract 1/2 if negative then skip to second routine, etc.
Frank Thomson
Experimental Noize
Experimental Noize
I said to subtract a 1/12, not mask it. Masking can help with removing noise from the POT but you still need to break the result into 12 parts.
Frank Thomson
Experimental Noize
Experimental Noize