Hi, I am making a pcb project at the moment which is not too complex. It will carry a ground plane on the underside of the PCB. I am just wondering if it may be that the Agnd and Dgnd would benefit by being separated.
I haven't read any info on how these Gnds are connected within the FV-1 so I am unclear If it is necessary to separate them.
Thanks
Seperating analogue and digital grounds
Moderator: frank
AGND and DGND are connected in the FV-1, separating on the PCB depends on a number of factors but it usually not really necessary.
Frank Thomson
Experimental Noize
Experimental Noize