Seperating analogue and digital grounds
Posted: Sat Nov 08, 2014 8:50 am
Hi, I am making a pcb project at the moment which is not too complex. It will carry a ground plane on the underside of the PCB. I am just wondering if it may be that the Agnd and Dgnd would benefit by being separated.
I haven't read any info on how these Gnds are connected within the FV-1 so I am unclear If it is necessary to separate them.
Thanks
I haven't read any info on how these Gnds are connected within the FV-1 so I am unclear If it is necessary to separate them.
Thanks