Coffecients and pot values
Posted: Fri Dec 05, 2014 5:02 pm
I'm a bit confused by what values of POT0-2 are supposed to be. According to docs and forum posts, the values are 0-1. But when I use a coefficient that represents the same range of values, the behaviors are not at all the same. Below is an example of a basic script where POT2 is a volume pot. If instead of POT2 I use the VOLUME coefficient, it doesn't work.
Code: Select all
equ VOLUME .75
rdax adcl, .5
rdax adcr, .5
mulx pot2 ;works
;mulx VOLUME ; doesn't work.
wrax dacl, 1
wrax dacr, 0