Is this a software error in the 3k_V1_1_Room.spn program
Posted: Sat Nov 21, 2015 11:59 am
Hi Frank,
I'm slowly learning to program the FV-1 and came across this snippet of code from the 3k_V1_1_Room.spn program written by Keith Barr I believe.
;prepare decay pot:
rdax pot1,0.97 ;get pot, limit to less than infinite
wrax krt,1 ;write loop decay time
sof 0.4,0.6 ;scale to 0.6 to 1.0
wrax kirt,0 ;write impulse filter gains
sof -1,0.99 ;scale to decrease gain with RT
wrax gain,0 ;write gain factor
Is the wrax kirt,0 command correct, which I think clears the ACC before the following sof -1,0.99 command? My thoughts are that it should read wrax kirt,1, am I correct?
Regards,
Steve
I'm slowly learning to program the FV-1 and came across this snippet of code from the 3k_V1_1_Room.spn program written by Keith Barr I believe.
;prepare decay pot:
rdax pot1,0.97 ;get pot, limit to less than infinite
wrax krt,1 ;write loop decay time
sof 0.4,0.6 ;scale to 0.6 to 1.0
wrax kirt,0 ;write impulse filter gains
sof -1,0.99 ;scale to decrease gain with RT
wrax gain,0 ;write gain factor
Is the wrax kirt,0 command correct, which I think clears the ACC before the following sof -1,0.99 command? My thoughts are that it should read wrax kirt,1, am I correct?
Regards,
Steve