I am using the chip on mono mode and wondering where it would be best to connect the unused I/O pins to minimize noise.
Should that be straight to reference (pin3) or maybe via a resistor or capacitor?
Any thoughts are welcome
where to connect unused input/output ?
Moderator: frank
Best to drive both inputs with the signal and leave the unused output unconnected to anything.
Frank Thomson
Experimental Noize
Experimental Noize
-
- Posts: 19
- Joined: Thu Oct 16, 2014 11:59 am
-
- Posts: 19
- Joined: Thu Oct 16, 2014 11:59 am