where to connect unused input/output ?

Hardware questions and issues with the FV-1

Moderator: frank

Post Reply
gkaiomenos
Posts: 19
Joined: Thu Oct 16, 2014 11:59 am

where to connect unused input/output ?

Post by gkaiomenos »

I am using the chip on mono mode and wondering where it would be best to connect the unused I/O pins to minimize noise.
Should that be straight to reference (pin3) or maybe via a resistor or capacitor?
Any thoughts are welcome
frank
Posts: 1244
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank »

Best to drive both inputs with the signal and leave the unused output unconnected to anything.
Frank Thomson
Experimental Noize
gkaiomenos
Posts: 19
Joined: Thu Oct 16, 2014 11:59 am

Post by gkaiomenos »

frank wrote:Best to drive both inputs with the signal and leave the unused output unconnected to anything.
So should I just jumper both inputs or maybe use separate signal cap to each input ??
frank
Posts: 1244
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank »

Separate signal caps.
Frank Thomson
Experimental Noize
gkaiomenos
Posts: 19
Joined: Thu Oct 16, 2014 11:59 am

Post by gkaiomenos »

frank wrote:Separate signal caps.
Great. I'll try that.
Thank you!
Post Reply