Spin Semiconductor Forum Index Spin Semiconductor
Support forum
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

FV-1 Dev Board - Output resistors and capacitors

 
Post new topic   Reply to topic    Spin Semiconductor Forum Index -> FV-1 hardware questions
View previous topic :: View next topic  
Author Message
skajam66



Joined: 10 Jun 2013
Posts: 13

PostPosted: Wed May 17, 2017 7:58 pm    Post subject: FV-1 Dev Board - Output resistors and capacitors Reply with quote

With reference to the FV-1 Dev Board schematic, what is the purpose of resistors R7, R8? Are they to allow the output capacitors to charge during power up when there is nothing physically connected to the output connectors?

If yes, can they be removed for designs where the output feeds other internal circuitry?

For the capacitors, can the value be changed to 0.47uF provided the input impedance of the following stage and the time constant for the capacitor charging meets the specification as laid out int he data sheet?
Back to top
View user's profile Send private message
frank



Joined: 19 Oct 2005
Posts: 972

PostPosted: Thu May 18, 2017 10:32 am    Post subject: Reply with quote

You can make any changes as required for your use but be aware that the DAC is a sigma-delta so it will require some low pass filtering to remove the out of band noise.
_________________
Frank Thomson
Experimental Noize
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    Spin Semiconductor Forum Index -> FV-1 hardware questions All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group