Spin Semiconductor

hi, noob here. i'm trying to create a "square wave" panner/tremolo to alternate between the right and left channels. the rate would be controlled by one of the control pots.

however, i would like to create a 'trapezoidal' waveform to provide appox. 7ms crossfade times (about 230 sampes at 32768) to reduce the transients.

in the docs on the site i've seen the application of using two ramp LFO's offset by half their period to create a crossfade/interpolation shape that is exactly the geometry i am trying to achieve, but i'm struggling to translate this technique into a waveform (and its inverse) that i can use as an amplitude multiplier for the incoming adcl and adcr respectively.

forgive me if this is obvious and i'm overlooking it, any help appreciated! thanks in advance. -theo

Hmmmm, good question. I'll need to think about it a bit. The hardware I designed to generate the waves doesn't directly map to instructions, it creates one ramp, derives the 2nd ramp, use them to create the waveform, etc.

thanks frank.

could one load a single ramp of appropriate length into a delay memory at start, then use zero crossings of one of the sine lfos (and a flip-flop counter) to trigger reading that out into register to multiply by the audio once per sine cycle (culminating the a steady-state coefficient until next sine zero-crossing)

just thinking out loud here. -t

Ugly way to make a trapezoidal wave from a ramp by making it a triangle and taking advantage of the saturation limiting to clip the peaks (some one check me on this )
To adjust the shape (faster slopes) add more "sof -2.0,0" commands

this turns out to work quite nicely frank, thank you! -t