SpinAsm - Writing to EEProm directly
Posted: Thu Oct 19, 2017 6:52 am
Hi
I know that I can write directly to Program Zero (Address = 000h) - the program does that by default, and I know that I can use the "Open Project Dialog" function to load finished programs to the places I want ...!...
But how do I "persuade" the program save to another program location when I press the Assemble button ?
I ask because I made a small plug that goes into Development board instead of the DIP 24LC32 and has a cable with a plug that goes onto my own hardware and program the SMD version of the 24LC32. This worked nicely on the first version that only used program zero, but the newest version use program 1-3 and I use a sequential increased revision part of the filename and would like to avoid using the "Open Project Dialog" every time I do so ....
I know that I can write directly to Program Zero (Address = 000h) - the program does that by default, and I know that I can use the "Open Project Dialog" function to load finished programs to the places I want ...!...
But how do I "persuade" the program save to another program location when I press the Assemble button ?
I ask because I made a small plug that goes into Development board instead of the DIP 24LC32 and has a cable with a plug that goes onto my own hardware and program the SMD version of the 24LC32. This worked nicely on the first version that only used program zero, but the newest version use program 1-3 and I use a sequential increased revision part of the filename and would like to avoid using the "Open Project Dialog" every time I do so ....