Page 1 of 1
Using the FV1 development board
Posted: Mon Jan 27, 2020 2:15 am
by Kink Guitar Pedals
Hi, Hoping someone can help me out here. I have three algorithms to upload using the development board, but can not do it for some reason. The file says its downloaded but nothing updates on the development board.
Im happy do do some reading if someone can point me in the right direction.
Cheers
Re: Using the FV1 development board
Posted: Mon Jan 27, 2020 8:07 am
by frank
Please post the exact steps you are doing and what the program says and make sure the switch on the board is set to external.
Re: Using the FV1 development board
Posted: Tue Jan 28, 2020 6:45 am
by Kink Guitar Pedals
I'm currently copying the text onto the page of the spin software and sending to the chip.
I just had a read and noticed there is a build project section. Is that what I should be using to program the 3 effects?
Re: Using the FV1 development board
Posted: Tue Jan 28, 2020 8:05 am
by frank
Yes, to write multiple programs to the EEPROM use project mode
Re: Using the FV1 development board
Posted: Tue Jan 28, 2020 5:40 pm
by Kink Guitar Pedals
Thank mate.