What to connect to the MID pin?

Hardware questions and issues with the FV-1

Moderator: frank

Post Reply
studionebula
Posts: 3
Joined: Mon Nov 10, 2008 10:04 am

What to connect to the MID pin?

Post by studionebula »

Forgive me if I've overlooked something in the spec sheet, but what exactly should I do with the MID pin in a new design? The Typical Application circuit in the spec sheet shows it connected to a 1uF cap whose other leg is connected to ground. The schematic for the development board shows a 10uF polarized cap instead. Is one preferable to another?

Thanks--
--Adam
frank
Posts: 1244
Joined: Wed Oct 19, 2005 12:26 pm
Contact:

Post by frank »

The value of the cap on the MID pin is not critical, 1uf or 10uf should work fine.
Frank Thomson
Experimental Noize
Post Reply